Primary Contents

• Can three G3PX Power Controllers for single-phase applications be combined for control of three-phase loads?
• Which terminals should the G3PX Power Controller inputs be connected to?
• What is a soft start?
• In PID control, what are the differences between ON/OFF time-sharing proportional control, cycle control, optimum cycle control, and phase control?
• How many G3PX Power Controllers can be connected to one Temperature Controller?
• If 200V is applied to the AC100V terminal, what will happen?
• What is a Power Regulator?
• What is the gradient setting?
• What are the conditions for detecting disconnection for G3PX-2[][]EHN-CT Power Controllers that detect disconnection for multiple heaters?
• Why is the same power supply used for both the circuit power supply and the load power supply?
• Is it possible to use a three-phase power supply for single-phase G3PX Power Controllers?
• Why does the constant-current model sometimes have all indicators ON?
• What is a level indicator?
• What is the minimum load current value that can be set?
• How much heating value flows from the Electrical Regulator "G3PX"?
• What is the constant-current function?
• What wiring should be used between a Temperature Controller and the G3PX Power Controllers?
• How should failure detection be wired?
• What is phase control?
• For the Electrical Regulator "G3PX" with the constant-current function, can protection be provided with the G3PX against load short circuiting?