GlobalQuestion
It seems that 61F's Floatless Level Controller electrodes are dirty and sensitivity has dropped. How can I clean them?
Answer
Tarnish on the electrodes will cause poor conductivity.
Polish the electrodes with an abrasive such as fine sandpaper.
Use a cloth to wipe off the residue.
The electrodes are stainless steel, so it is also acceptable to use a commercial chemical cleanser, but be sure that the liquid in the container is not affected. If the electrodes are extremely dirty, it may be necessary to replace them.
Recommended Products
Other Level Switches FAQ
-
Why do the specifications for the High-sensitivity 61F Floatless Level Controller say, "possible to use with 15 kOHM or less, however, this may cause reset failure"?
-
Can two 61F Floatless Level Controllers and two Electrode Holders be used in the same tank?
-
When voltage is applied to 61F Floatless Level Controller, it operates regardless of the actual liquid level. What is the cause of the problem and how can it be corrected?
FAQ
Top of page
© Copyright OMRON Corporation 2007 - 2024. All Rights Reserved.
