Global
These are navigation links to move inside this page.
Quick links to OMRON IA in your country.
-
- Middle East
-
Please contact OMRON Europe B.V. in Netherlands.
Question
How should failure detection be wired?
Answer
Power Controller G3PX power supply should be wired from the circuit breaker or contactor to protect the circuit by operating the host circuit breaker or contactor using the G3PX failure detection relay output.
The alarm output cannot be reset if it is wired from the secondary side.
Other Power Controllers FAQ
-
In PID control, what are the differences between ON/OFF time-sharing proportional control, cycle control, optimum cycle control, and phase control?
-
If 200V is applied to the AC100V terminal, what will happen?
-
Why is the same power supply used for both the circuit power supply and the load power supply?
Top of page
© Copyright OMRON Corporation 2007 - 2008. All Rights Reserved.
