GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
FAQ00969 for Rotary Encoders | OMRON Industrial Au...- ...ead Contents FAQ No. FAQ00969 Related Contents Primary Contents Question How many meters of the cable of the Rotary Encoder are extended? Answer Voltage output and open collector output typ...
- FAQ00978 for Rotary Encoders | OMRON Industrial Au...
- ... is almost possible by making cut face "D" of the shaft and the direction of drawing out of the cable as the following figure. (within ±15°) E6C3-CWZ[][]H 3. Please confirm ON point of phase ...
- FAQ01004 for Rotary Encoders | OMRON Industrial Au...
- ...e change of output data and reading timing by becoming long at the rise time of signal when the cable is extended. We recommend the rotary encoder with the strobe signal that informs of readi...
- FAQ02207 for General Purpose Relays | OMRON Indust...
- ....01 to 0.12 8 8 0.12 to 0.14 7 9 0.14 to 0.15 6 10 0.15 to 0.18 5 12 0.18 min. 4 15 Note: 1.CVV cable: Nominal conductor cross-section area: 2 mm 2 (7 conductors), Floating capacity between w...
- faq02761
- ...y from a distance? Answer The distance depends on the type and installation conditions of the cable. Wiring power supplies over a long distance in parallel with power lines may cause reset ...
- faq02770
- ...al-purpose Relays? Answer The distance depends on the type and installation conditions of the cable. Both ends of the Relays coil must measure at least 90% of the rated coil voltage to oper...
- faq02799
- ....01 to 0.12 8 8 0.12 to 0.14 7 9 0.14 to 0.15 6 10 0.15 to 0.18 5 12 0.18 min. 4 15 Note: 1.CVV cable: Nominal conductor cross-section: 2 mm 2 (7 conductors), Float capacitance between wires:...
- faq02828
- ... wires or leakage current when Relays is OFF. This may also cause reset failure. Check with the cable manufacturer for how much float capacitance the cables retain. Also check the amount of l...
- faq00380
- ...graded because of degradation of the internal filling resin, sensing surface resin material, or cable sheath due to ultraviolet light. Stress on Filling Resin Due to Sudden Temperature Change...
- FAQ00402 for Proximity Sensors | OMRON Industrial ...
- ...ntents FAQ No. FAQ00402 Related Contents Primary Contents Question Is it possible to extend the cable of the Proximity Sensor? Answer Yes, it provides as follows in each type of the sensor....
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation