...V DC Load Load Load Pink Purple Timing input Orange Zero reset input Red Current/voltage output selector 100 Ω 4 Blue GND (0V) Judgement output hold input Current output (4 to 20mA) Voltage o...

https://www.fa.omron.co.jp/data_pdf/cat/zx-t_e345-e1_2_3_csm1741.pdf

...全区域や安全状態を確保します。 3）偶発起動および不正操作の防止 （1）セーフティ・キーセレクタスイッチ （Safety Key Selector Switch） 1. 片手による不正操作防止両操作器間は、水平距離で2...

https://www.fa.omron.co.jp/data_pdf/commentary/safetycompo_tg_j_2_1.pdf

...fault) MC MA S1 ON (EDM output) OFF (Terminal P1 output) (Factory default) Terminating Resistor Selector Switch OFF Braking resistor N/- S2 EDM Function Selector ...

https://www.fa.omron.co.jp/data_pdf/mnu/3g3mx2-a_-v2_-ev2_inst-5716095-5a.pdf

...itialization All the settings are initialized and returned to the default setting. Example Mode selector Operation and description Indicators （Value） Shows the sensing level.*１ / Workpiece...

https://www.fa.omron.co.jp/data_pdf/mnu/e2cy_inst-2159957-8c.pdf

...(14) Mode switch (12) Sub-display Section 2 Part Names and Functions (4) Output cable (13) Threshold switch (1) The input cable connects the Sensor Head. (2) The current/voltage...

https://www.fa.omron.co.jp/data_pdf/mnu/e346-e1-06_zx-t.pdf

...ly, malfunction or chattering may be caused by mutual interference. For model E3C photoelectric switch, if the response time selector switches are set differently each other, mutual ...

https://www.fa.omron.co.jp/data_pdf/mnu/e3c-wh4f_-we_inst-6954845-2b.pdf

...Models with timer 定时器动作型 スイッチの選定方法 Switch selection 开关选定方法 MODE 0 1 D · ON L · ON D · ON Operation selector 动作模式 切换开关 D · ON MODE 0 1 D · ON SW2 動作モー...

https://www.fa.omron.co.jp/data_pdf/mnu/e3jm_inst-1135329-5f.pdf

...方法 MODE 0 1 D · ON MODE 0 1 L · ON D · ON MODE 1 0 D · ON L · ON 動作モード 切替スイッチ Operation selector 动作模式 切换开关 MODE 0 1 D · ON SW2 動作モード,切替スイッチ OFF ディレイ/delay/...

https://www.fa.omron.co.jp/data_pdf/mnu/e3jm_inst-5732692-6a.pdf

...etting) 2-5 Smart Tuning [Easy Sensitivity Setting] ■Joining Amplifier Units button. L/D Output Selector [NO/NC] Button A single press switches between NO (Normal Open)/NC (Normal Close). [NO...

https://www.fa.omron.co.jp/data_pdf/mnu/e3nx-ca0_inst-9531853-8d.pdf

...1 second under [Detection Mode]. OUT Selection Indicator (Output 2) 2-3 Output switching Output Selector [NO/NC] Button A single press switches between NO (Normal Open)/NC (Normal Close). [NO...

https://www.fa.omron.co.jp/data_pdf/mnu/e3nx-ca___inst-9530588-6d.pdf

...display (green) MODE ⑦ Operation keys ⑧ Lock button ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ RUN 2 SET RUN L D ⑤ SET/RUN switch ⑥ Operation mode selector Lit when the output is ON. Displays the incident ligh...

https://www.fa.omron.co.jp/data_pdf/mnu/e3x-da__tg-s_inst-5319306-9b.pdf

...lack C/Q 1 Connector Extension Models(M12) Connector Models(M8) ** Slowly revolve the operation selector switch and potentiometer using a small flat-head screwdriver according to the...

https://www.fa.omron.co.jp/data_pdf/mnu/e3z-_8_-il__inst-9540404-3b1.pdf

...ective type L L Light ON Diffuse reflective type Narrow beam type ** Slowly revolve the operation selector switch and potentiometer using a small flat-head screwdriver according to the...

https://www.fa.omron.co.jp/data_pdf/mnu/e3z-il-ul_inst-3665867-8b.pdf

...because it might get the frozen burn. (5) Rotating torque of sensitivity adjuster and operation selector Adjusting torque is 0.06N・m max. (6) Oil environment Do not use the sensor in the oil...

https://www.fa.omron.co.jp/data_pdf/mnu/e3zm-____inst-7978985-7h.pdf

...because it might get the frozen burn. (5) Rotating torque of sensitivity adjuster and operation selector Adjusting torque is 0.06N・m max. (6) Alteration Never disassemble, repair nor tamper ...

https://www.fa.omron.co.jp/data_pdf/mnu/e3zm-c____inst-0979013-0h.pdf

...ontrolled system. · Turn the power supply to the Temperature Controller OFF before changing any switch setting. Switch settings are read only when the power supply is turned ON. · Ma...

https://www.fa.omron.co.jp/data_pdf/mnu/e5cs-u_inst-2162665-6a.pdf

...ller so that they are appropriate for the controlled system. • Do not set the temperature range selector switch to any setting that is specified not to be set. An unexpected range ma...

https://www.fa.omron.co.jp/data_pdf/mnu/e5cs_former_model_inst-1618455-6a.pdf

...with detecting liquid 1.6 26 12.4 9.2 1.8 17.2 1 13 LIGHT INDICATOR 8.1 4.9 3.1 3.5 SENSITIVITY SELECTOR SWITCH OPTICAL AXIS The voltage supplied to the product must be within the ra...

https://www.fa.omron.co.jp/data_pdf/mnu/ee-spx613_inst-5977172-2g.pdf

...hesis,( ),indicates a pin number of the connector of the Sensor. ■Operation mode / Timing chart selector State of output L・ON D・ON Light ON Dark ON No optical axis is interrupted chart Ligh...

https://www.fa.omron.co.jp/data_pdf/mnu/f3w-d052a__-d052b__inst-9307938-2b.pdf

.... Numerical value inside parenthesis,( ),indicates a pin number of the connector of the Sensor. selector （External picking indicator output type） Emitter has the following code. Other dimen...

https://www.fa.omron.co.jp/data_pdf/mnu/f3w-d052c__-d052d__inst-9309466-7b.pdf