...tery 5 To perform shutdown processing of the devices when a power failure occurs 3. Pull up the lever of the battery control board toward you. Lever 4. Insert a tool such as a screwd...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/u702-e1-11_s8ba-24d24d___lf.pdf

...or 8-position DIP switch for system settings Slide switch for memory settings (SW2) Socket with lever, for installing image data memory Socket for mounting System ROM (NT20M-SMRjj) Terminal b...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/v001-e1-02_nt20m_nt2000m.pdf

...ite) Materials Dimensions V400-H111/211/111-1 (Unit:mm) LCD MONITOR MEMORYCARD INSERT HOLE ZOOM LEVER BUZZER Omron Companies shall not be responsible for conformity with any standards, codes ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/v400-h111_211_111-1_inst-7978637-8f.pdf

...ing the lock levers at the top and bottom of the terminal block. 3. While pushing down the lock lever on the Backplane with a screwdriver as shown below, remove the Output Unit. 4. Remove the...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w111-10_c200h-cpu01-e_03-e_11-e.pdf

...nit to be removed from the CPU for up to 10 minutes without memory loss. Memory element Pullout lever CPU connector Backup capacitor Expansion Data Memory Unit 35 Section 2-3 Rack Components ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w195-e1-08_cv500_1000_2000_cvm1.pdf

... bottom of the terminal block. 68 Section 8-3 Output Unit Relays 3. While pushing down the lock lever on the Backplane with a screwdriver as shown below, remove the Output Unit. 4. Using a Ph...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w218-06_c200h-cpu21-e_23-e_31-e.pdf

...s on the sides of the connector and pull the connector straight out to disconnect. Lock release lever Switch Settings and Adjustments PC Switch Settings Set the DIP switch to a baud rate of 5...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w222-03_cvm1-prs21-ev1.pdf

...lane and rotating the I/O Unit downwards as shown in the following diagram. Hook Backplane Lock lever Press down on the yellow lock lever at the bottom of the slot, press the I/O Uni...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w236-e1-07_c200hs.pdf

...Z Note It is possible to adjust the buzzer volume on the C200H-PRO27-E using the volume control lever on the side of the Programming Console. 3-3-6 Reading and Changing Expansion Instructions...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w250-e1-02_idsc-c1dr_c1dt-a-e.pdf

...lane and rotating the I/O Unit downwards as shown in the following diagram. Hook Backplane Lock lever Press down on the yellow lock lever at the bottom of the slot, press the I/O Uni...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w302-e1-15_c200hx_hg_he_setup.pdf

...cifications, refer to the relevant PC manual. 6-2-2 Nomenclature Peripheral Port Connector Lock Lever EEPROM Socket Indicator UPLOAD + DM Button DOWNLOAD to PLC Button UPLOAD Button Lock...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w318-e1-05_srm1_v2.pdf

...sert the hook on the upper rear of the Unit into the slot in the Backplane. Hook Backplane Lock lever 2. Carefully insert the Unit into the connector on the Backplane. 5 Section System Config...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w334-e1-04_c200hw-nc.pdf

...O and I/O Interface Units are all OFF before performing Relay replacement. 1,2,3... 1. Push the lever for the Relay to be replaced and remove the Relay. The Relays are arranged in order, with...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w348-e1-08_drt1-com_gt1.pdf

...0 to E32765 x 4 banks CV1000-DM251 256K words E00000 to E32765 x 8 banks Memory element Pullout lever CPU connector Backup capacitor EM Unit When mounted to the CPU, the EM Unit is backed up ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w350-02_cvm1d-dpl.pdf

...gram shows the structure of the EM Unit and identifies its main components. Memory chip Pullout lever CPU connector Backup capacitor EM Unit The EM Area operates the same as the DM Area, but ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w351-e1-03_cvm1d-dpl.pdf

...sole. Contrast control Buzzer Volume The C200H-PRO27-E’s buzzer volume can be adjusted with the lever on the right side of the Programming Console. The CQM1-PRO01-E’s buzzer volume cannot be ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w352-e1-07_cpm2a.pdf

...nection terminals 450 g max. • CS1W-PTS55/-PTS56/-PDC55 24-point removable terminal block (with lever) (M3 screws, Tightening torque: 0.5 N·m) • Other Units 21-point removable terminal block ...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w368-e1-10_cs1w-p____cj1w-p___.pdf

...Push the cable’s connector into the Board’s connector until both lock levers lock solidly. Lock lever To remove the Expansion I/O Cable, open the connectors lock levers and pull out the cable...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w371-e1-03_cpm2b.pdf

...Push up the orange tab and then insert each line into the back of each hole. Release the orange lever after inserting the lines, and gently pull each line to check that it is securely connect...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w454-e1-04_grt1-drt.pdf

... 2-3 Connecting to the CompoNet Network 2 Black Cable labels (Black, blue, white, and red) Lock lever 1. At the tip of cable, cut the cable perpendicular to the cable length. To prevent short...

https://www.fa.omron.co.jp/data_pdf/closed/mnu/w484-e1-01_crt1-vad02_d_vda02_d.pdf