...the Unit. •Do not connect pin 6 (+5V) on the RS–232C port to any external device other than the NT–AL001 or CJ1W–CIF01 Conversion Adapter. The external device and the Unit may be damaged. •Th...

https://www.fa.omron.com.cn/data_pdf/mnu/cs1w_cj1w-scu_-sbc_(safetyprecautions)_inst-0675497-4d.pdf

...機器およびCPUユニットが故障する恐れがあります。 ●CPUユニットのRS-232Cポートの6番ピン（+5V電源）は、変換アダプタ形NT-AL001/形CJ1W-CIF01以外の外部機器には接続しないでください。 外部機器およびCP...

https://www.fa.omron.com.cn/data_pdf/mnu/csseries(cs1w-etn21_-mc221-v1)(safetyprecautions)_inst-9542843-0b.pdf

...部设备或CPU单元。 ●请不要把安装到CPU单元内置RS232C端口、或CPU单元的RS-232C备选板的第6脚(+5V电源)与转换适配器形CJ1W-CIF11/形NT-AL001/ 形NV3W-M□20L可编程终端以外的外部设备连接。 否则可能导致外...

https://www.fa.omron.com.cn/data_pdf/mnu/k3616435-7a_ch.pdf

...上、ご使用ください。 ●シリアルポートＣ（コントローラ部のRS-232Cポート）の6番ピン（＋5V電源） は、変換アダプタ形CJ1W-CIF11／形NT-AL001以外の外部機器には接続しないでください。 外部機器およびNSJ...

https://www.fa.omron.com.cn/data_pdf/mnu/nsj(safetyprecautions)_inst-2109296-1c.pdf

...0.7m）/ MPT－CN200（2m）/ MPT－CN400（4m）/ MPT－CN550（5.5m）/ MPT－CN1000（10m） C、MPT5通过RS422端口与PLC连接。 要通过NT－AL001或者CPM1A-CIF11与PLC联接， 图（17） 图（18） PLC NT-AL0001 MP...

https://www.fa.omron.com.cn/data_pdf/mnu/oezp0010209-1_mpt5.pdf

...ication Communication Unit Type Code PLC For PLC side, dedicated cable XW2Z-070T-1 is required. NT-AL001 Direct connection with RS232 type 9-pin connector at PLC. CJ1W-CIF11 RS422 Converter S...

https://www.fa.omron.com.cn/data_pdf/mnu/r123-e1-01_fb_library.pdf

...元用户手册内置I/O、扩展板功能篇(SBCA-449)”。 通信状态显示LED RS-232C端子台因为没有+5V电源端子，所以无法连接CJ1W-CIF11、NT-AL001等外部转换设备和可编程终端 NV3W-M20L。 端子台无法拆装。 3-3-2...

https://www.fa.omron.com.cn/data_pdf/mnu/sbca-cn5-448c.pdf

...ule side, refer to the manual for the computer link module. Parts for RS-232C (Common to PT and NT-AL001) Part Model Remarks Connector XM2A-0901 9-pin type, made by OMRON XM2A-2501 25-pin typ...

https://www.fa.omron.com.cn/data_pdf/mnu/v042-01_nt31_nt31c_nt631_nt631c.pdf

............................................................................................25 2.6与NT-AL001连接.....................................................................................

https://www.fa.omron.com.cn/data_pdf/mnu/v059-cn5-01_mpt002.pdf

...and the conditions at the operation site. Reference: When using an RS-232C/422A convertor unit (NT-AL001) with the host link or 1:1 NT Link communication method, RS-485 cannot be used. The co...

https://www.fa.omron.com.cn/data_pdf/mnu/v064-02_nt31_nt31c_nt631_nt631c.pdf

.........................................................................................A-26 附录5使用NT-AL001转换器................................................................................

https://www.fa.omron.com.cn/data_pdf/mnu/v083-cn5-05_ns.pdf

.............................................................................A-28 Appendix 4 Using NT-AL001 Converters ..............................................................................

https://www.fa.omron.com.cn/data_pdf/mnu/v083-e1-33_ns5_8_10_12_15.pdf

...-232C端口这一部分介绍了如何通过连接适配器把多台NT11的RS-232C端口与上位机的 RS-232C端口相连接。 RS-232C/RS-422A转换单元（NT-AL001或者NS-AL002） 用于在RS-232C和RS-422A通信方式之间的转换。 NT11...

https://www.fa.omron.com.cn/data_pdf/mnu/v084-cn5-01_nt11.pdf

...ance settings correctly. (SECTION 2 Hardware Set- tings and Connections) The power to the NT11, NT-AL001 or host is OFF. Check the power supply. The buzzer has sounded and the RUN Indicator i...

https://www.fa.omron.com.cn/data_pdf/mnu/v084-e1-01_nt11.pdf

...te 1. The Open Network Controller does not have a 5-V output. Provide a 5-V power supply to the NT-AL001-E Link Adapter from an external source. 2. This example shows the connector pin layout...

https://www.fa.omron.com.cn/data_pdf/mnu/v228-e1-02_itnc-epx-drm.pdf

...via an RS-232C port to enable data transfer via NT Link commands. CPU Unit Communications Board NT-AL001 Link Adapter (RS-232C to RS-422A/485 conversion) RS-232C RS-232C PT PT PT PT Protocol ...

https://www.fa.omron.com.cn/data_pdf/mnu/w304-e1-05_c200hw_com01_com02_v1-06_v1.pdf

...––– SG 7 8 9 1 2 3 4 5 6 7 8 9 – SD RD RS CS –– SG RS-232C Port Pin No. Signal – Pin No. Signal NT-AL001 Hood Ribbon line (red) Ribbon line (black) 1:1 Connection 1 2 3 4 5 6 – SD RD RS CS ––...

https://www.fa.omron.com.cn/data_pdf/mnu/w318-e1-05_srm1_v2.pdf

...)中的某一位变为ON。 电缆连接不正确。 RS-422A/485的端口2上的2线制/4 线制选择开关的设定与配线不匹配。 适配器(NT-AL001 等)配线不正确。 检查电缆连接。 将通信板端和最终目的地设备上的终端电阻(终端...

https://www.fa.omron.com.cn/data_pdf/mnu/w344-cn5-12_cx-protocol.pdf

...rts on the Controller Section) to any external device except the CJ1W- CIF11 RS-422A Adapter or NT-AL001 RS-232C/RS-422A Adapter. Doing so may damage the external device or NSJ Controller. •W...

https://www.fa.omron.com.cn/data_pdf/mnu/w452-e1-08_nsj_setup.pdf

... power supply terminal, it cannot be connected to external converters such as an CJ1W-CIF11 and NT-AL001, or an NV3W-M£20L Programmable Terminal. The terminal block is not removable. RS-422A/...

https://www.fa.omron.com.cn/data_pdf/mnu/w578-e1-14_nx1p2.pdf