...d Surge Effects If noise or an electrical surge occurs that exceeds the mal- function withstand limit for the G3PH output circuit, the output will turn ON for a maximum of one half cycle to a...

https://www.fa.omron.com.cn/data_pdf/cat/g3ph_j177-e1-01.pdf

...d Surge Effects If noise or an electrical surge occurs that exceeds the mal- function withstand limit for the G3PH output circuit, the output will turn ON for a maximum of one half cycle to a...

https://www.fa.omron.com.cn/data_pdf/cat/g3ph_j177-e1_2_1_csm1000554.pdf

...同步转矩模式)·Profile position mode (轨迹位置模式) ·Homing mode (原点复位模式)·Touch probe function (锁定功能)·Torque limit function (转矩限制功能) 机型型号单元版本单元Ver.1.0单元Ver.2.0单元V...

https://www.fa.omron.com.cn/data_pdf/cat/g5_series_i819-cn5_1_10.pdf

...er supply. Incorrect wiring may result in burning. •Do not bend the cables beyond their natural limit. Doing so may break the cables. •Do not pull the cables by the power beyond 30 N. Doing s...

https://www.fa.omron.com.cn/data_pdf/cat/g70d-soc08_ds_e_5_1_csm1046356.pdf

... Must Operate time *2 15 ms max. Release time *2 15 ms max. Max. switching frequency Mechanical limit 18,000 operations/h At rated load 1,800 operations/h Insulation resistance 100 MΩ(at 500 ...

https://www.fa.omron.com.cn/data_pdf/cat/g7tc_ds_e_9_1_csm1046354.pdf

...(PLe/Safety category 4) 3 Omron has a complete range of safety solutions, from E-stop, door and limit switches to safety sensors and safety mats. The Omron G9SP is part of the most extensive ...

https://www.fa.omron.com.cn/data_pdf/cat/g9sp_f090-e1_12_9_csm2603.pdf

...C Transistor (Photocoupler) 24 to 48 VAC (50/60 Hz)/ 12 to 48 VDC 0.05 s to 300 h H3CR-A8S Time-limit contact and instantaneous contact 100 to 240 VAC (50/60 Hz)/ 100 to 125 VDC H3CR-A8E 24 t...

https://www.fa.omron.com.cn/data_pdf/cat/h3cr_l084-e1_3_6_csm1013792.pdf

...Conditional short-circuit current 1,000 A Ambient Operating Temperature and Carry Current Upper limit of ambient temperature (°C) Carry current AC/DC (A) Note that the upper limit of...

https://www.fa.omron.com.cn/data_pdf/cat/h5l_ds_e_2_4_csm102.pdf

...liary contact 2PST-2NO) J73KC-AM-40 (Auxiliary contact 4PST-4NO) TH SA G9SA-301 (AC/DC24V) (two limit switch input channels with manual reset) Feedback circuit Feedback loop Recommended repla...

https://www.fa.omron.com.cn/data_pdf/cat/j7kc_j230-e1_9_1_csm1074607.pdf

...) [cycles/hour] 25 Phase failure protection Yes Trip indicator Yes Test trip function Yes Rated limit breaking capacity Icu: Rated limit breaking capacity [kA] (Breaking duty O-CO) I...

https://www.fa.omron.com.cn/data_pdf/cat/j7mc_j233-e1_5_1_csm1074610.pdf

...ip class 10 A 3-pole load operation (At 20°C ambient temperature) IEC 60947-4-1/ JIS C 8201-4-1 Limit operation No operation (cold start) 105% (less than 2 hours) *1 Operation (hot start) 120...

https://www.fa.omron.com.cn/data_pdf/cat/j7tc_j231-e1_7_1_csm1074608.pdf

.... The longer the wire length, the larger the measurement error using the KM-NCT-E becomes. •The limit of the wiring length can also be calculated by the following formula. Calculate the wirin...

https://www.fa.omron.com.cn/data_pdf/cat/km-n2_km-n3_n213-e1_3_13_csm1050147.pdf

...sed. 20 80 100 30 C10004 C10005 C10006 80 100 30 DM0300 DM0302 DM0304 Alarm value 1 Alarm upper limit value 1 Alarm lower limit value 1 80 100 30 DM0300 DM0302 DM0304 80 100 30 C1000...

https://www.fa.omron.com.cn/data_pdf/cat/ns_v405-e1_12_12_csm2140.pdf

...ations Parts Names ■NSJ Controllers Note 1. A delay circuit that charges a capacitor is used to limit the inrush current. If a hot start is performed when the power supply has been OFF only a...

https://www.fa.omron.com.cn/data_pdf/cat/nsj_v406-e1_7_8_csm2192.pdf

...ion outputs a fixed manipulated variable when a Sensor Disconnected Error occurs. All models MV Limit This function adds a limit to the manipulated variable calculated by PID control...

https://www.fa.omron.com.cn/data_pdf/cat/nx-tc_nx-htc_h229-e1_2_2_csm1061207.pdf

...ask numbers can be registered. Range comparison Up to 8 ranges can be registered, with an upper limit, lower limit, and interrupt task number for each. Counter reset method Phase-Z +...

https://www.fa.omron.com.cn/data_pdf/cat/p04e-en-03a cj1 groupcat.pdf

...eed can be switched between 16 settings while positioning during multi-speed operation. Without limit reversal Use the ON/OFF signal of any of the following: Origin proximity signal + origin ...

https://www.fa.omron.com.cn/data_pdf/cat/r88a-ncw152-drt_i808-e1-01.pdf

...odels without options. *4.The allowable radial and thrust loads are the values determined for a limit of 20,000 hours at normal operating temperatures. The allowable radial loads are applied ...

https://www.fa.omron.com.cn/data_pdf/cat/r88m-1l_-1m__i831-e1-01.pdf

...hibit Input Servo Ready Output General-purpose Output 2 General-purpose Output 1 Forward Torque Limit Input Reverse Torque Limit Input 20 100Ω 4.7 kΩ 1μF SEN SENGND 13 Sensor ON BAT ...

https://www.fa.omron.com.cn/data_pdf/cat/r88m-g_r88d-gt_i814-e1_15_16_csm2686.pdf

...s INPUT OK Indicator The INPUT OK indicator will light when the input voltage exceeds the lower limit value of the permissible range. Note: The voltage may be applied even if the indicator do...

https://www.fa.omron.com.cn/data_pdf/cat/s8vk-w_t219-e1_5_1_csm1066917.pdf