..., E5EC-T, E5AC-T E5CD, E5CD-B, E5ED, E5ED-B E5CD-H, E5ED-H E5ZN *1 EJ1N-TC4, EJ1N-TC2, EJ1N-HFU G3ZA (only when connected to EJ1N-TC4, EJ1N-TC2) G3PW (only when connected to EJ1N-TC4, EJ1N-TC...

https://www.omron.com.au/data_pdf/cat/est2-2c-mv4_ds_e_10_9_csm223.pdf

... inverse proportion to the output duty. 5. When used in combination with optimal cycle control (G3ZA), the heater burnout detection function cannot be used. 6. Do not set the heater burnout d...

https://www.omron.com.au/data_pdf/cat/g3pf_ds_e_7_11_csm748.pdf

...Multi-channel Power Controller G3ZA CSM_G3ZA_DS_E_6_4 Optimum Cycle Control for High-precision Control with Low Noise ® • Smaller than a Normal Power Controller. • Enables low-noise ...

https://www.omron.com.au/data_pdf/cat/g3za_ds_e_6_4_csm192.pdf

... keep this pin set to OFF so that the operation status can be checked. Set to ON when using the G3ZA. Used when using an Advanced Unit and distributed installation. (Refer to the User's Manua...

https://www.omron.com.au/data_pdf/mnu/ej1-edu_inst-1132575-5c.pdf

...edUnbt CN1 1 m ㌔瑠囮1融ヨ是阻皿,[[=]ロコ] ConnecttheG3ZA harnesstotheCNl connectoronthe bottomoftheUnit. G3ZA 1 SetSW2to3(576 kbps). ・W B1 輌 A1 B2 ⑪ ⑪ ・A2 B3 ⑪ ⑪ ,A3 B4 ⑪ ⑪ ・A4 B5 ⑪ ⑪ ・...

https://www.omron.com.au/data_pdf/mnu/ej1-edu_inst-1618691-5f.pdf

...ort A. Flashes during communications on End Unit port B. Flashes during communications with the G3ZA. • Wiring Procedure for Screw-Less Clamp Terminals There are two holes for each terminal. ...

https://www.omron.com.au/data_pdf/mnu/ej1_inst-5724841-0a.pdf

...User's Manual (Cat. No. W500) and NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501). G3ZA Multi-channel Power Controllers Cat. No. Z200 Model number G3ZA-4H203-FLK-UT...

https://www.omron.com.au/data_pdf/mnu/h192-e1-02_ej1n-hfuc-ect.pdf

...isplay position for RGB display. SAP has been added for the EJ1 Modular Temperature Controller, G3ZA Multi-channel Power Controller, and Troubleshooters. Symbol names and I/O comments of the ...

https://www.omron.com.au/data_pdf/mnu/v088-e1-03_ns-cxdc1-v2.pdf

...nd analog input for easy selection and reduced inventory requirements. •Connect directly to the G3ZA Multi-channel Power Controller using optimum cycle control for high-accuracy regulation wi...

https://www.omron.com.tw/data_pdf/cat/ej1_ds_e_12_5_csm222.pdf

...sion control with low noise through multi-channel power controllers with optimal cycle control (G3ZA, up to 8 units) is possible. •Autotuning (AT) can be used for independent heating/cooling ...

https://www.omron.com.tw/data_pdf/cat/ej1_h236-e1_4_1_csm1121137.pdf

...、CJ1等為同一尺寸。 並可透過終端模組進行分散配置以排除無效空間，有效運用面板內的空間。 直接與多點電力控制器G3ZA連結， 以達到最佳週期控制一台基本模組最多可直接連接8台G3ZA。 透過最佳週...

https://www.omron.com.tw/data_pdf/cat/ej1_sgtd-045_tw_5_8.pdf

..., E5EC-T, E5AC-T E5CD, E5CD-B, E5ED, E5ED-B E5CD-H, E5ED-H E5ZN *1 EJ1N-TC4, EJ1N-TC2, EJ1N-HFU G3ZA (only when connected to EJ1N-TC4, EJ1N-TC2) G3PW (only when connected to EJ1N-TC4, EJ1N-TC...

https://www.omron.com.tw/data_pdf/cat/est2-2c-mv4_ds_e_10_9_csm223.pdf

...、E5EC-B型、•EJ1N-TC4型、EJ1N-TC2型、EJ1N-HFU型 E5AC型、E5DC型、E5DC-B型•E5CD型、E5CD-B型、E5ED型、E5ED-B型 •E5ZN型 •G3ZA型（連接EJ1N-TC4型、EJ1N-TC2型時） •G3PW型（連接EJ1N-TC4型、EJ1N-TC2型...

https://www.omron.com.tw/data_pdf/cat/est2-2c-mv4_ds_tw_10_5.pdf

... inverse proportion to the output duty. 5. When used in combination with optimal cycle control (G3ZA), the heater burnout detection function cannot be used. 6. Do not set the heater burnout d...

https://www.omron.com.tw/data_pdf/cat/g3pf_ds_e_7_11_csm748.pdf

...作負載50％以上時可進行斷線檢測。 ） 註4.如為循環控制，檢測時間會與輸出工作負載成反比。 註5.若與最佳循環控制（G3ZA型）組合使用，無法使用加熱器斷線檢測功能。 註6.設定加熱器斷線檢測電流時，請勿...

https://www.omron.com.tw/data_pdf/cat/g3pf_ds_tw_7_9.pdf

...CSM_G3ZA_DS_E_6_4 1 Multi-channel Power Controller G3ZA Optimum Cycle Control for High-precision Control with Low Noise •Smaller than a Normal Power Controller. •Enables low-noise po...

https://www.omron.com.tw/data_pdf/cat/g3za_ds_e_6_4_csm192.pdf

...CSM_G3ZA_DS_TW_6_2 1 多點電力調整器G3ZA 透過最佳週期控制使雜訊抑制在低雜訊的範圍，同時帶來高精度的可控制性 •體積比一般電力調整器更小。 •搭配附零交叉功能的SSR一起使用， 可進行雜訊較少...

https://www.omron.com.tw/data_pdf/cat/g3za_ds_tw_6_2.pdf

...ower the lever. PFP-M Vertically: OK Horizontally: Not OK ⑥ ⑤ SW2 SW1 ERROR OCC SD/RD READY CN1 G3ZA B1 B2 B3 B4 B5 B6 B7 B8 B9 OUT2 OUT1 ch2 DC12V DC12V TC + + + – – A B B Voltage output Vol...

https://www.omron.com.tw/data_pdf/mnu/ej1-edu_inst-1132575-5c.pdf

...dUnbt CN1 1 m ㌔瑠 囮1融ヨ是阻皿,[[=]ロコ] ConnecttheG3ZA harnesstotheCNl connectoronthe bottomoftheUnit. G3ZA 1 SetSW2to3(576 kbps). ・W B1 輌 A1 B2 ⑪ ⑪ ・A2 B3 ⑪ ⑪ ,A3 B4 ⑪ ⑪ ・A4 B5 ⑪ ⑪ ・...

https://www.omron.com.tw/data_pdf/mnu/ej1-edu_inst-1618691-5f.pdf

...nd distributed installation. (Refer to the User's Manual for details.) Set to ON when using the G3ZA. * Do not connect an End Unit directly to an Advanced Unit. * Always connect an End Unit t...

https://www.omron.com.tw/data_pdf/mnu/ej1_inst-5724841-0a.pdf