GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
faq04624- ...ents Question According to the manual, the NJ501-1300 has a program capacity of 20 MB. How many K steps is 20 MB? Answer A program capacity of 20 MB is roughly the same as 400 K st...
- faq00541
- ...0541 Related Contents Primary Contents Question When can the manual reset be used for E5[]N/E5[]K Temperature Controllers? Answer The manual reset can be used for P or PD control. There is ...
- FAQ00553 for Temperature Controllers | OMRON Indus...
- ...rrecting PID constants when hunting occurs to eliminate hunting. Applicable Models: Thermac the K, and N Series * The N Series supports only mode 1. The step response method, a typical calcul...
- faq00640
- ...Question Can current outputs (4 to 20 mA DC) be used for the heating and cooling outputs of E5[]K Digital Controllers? Answer Current outputs can be used by adding E53-C3 Current output Uni...
- faq03236
- ...te 3 Note: 1.The [] in E5C4 model number indicates the type of input temperature sensor. It is "K" for the CA Thermocouple, "J" for the IC Thermocouple, and "P" for the Pt100 Resistance Therm...
- faq03560
- ...lect the Controller depending on the output type and any other conditions.) E5CN-[]L Series E5[]K Series Digital Controllers Temperature The temperature output of ES2-THB is the output of a P...
- FAQ02939 for Digital Panel Indicators | OMRON Indu...
- ...n Support Software "ThermoTools"? Answer "ThermoTools" can be used with the E5[]R, E5[]N, E5[]K, E5ZN, and E5ZE Temperature Controllers; the K3N[] and K3GN Digital Panel Indicator; and the ...
- faq03560
- ...lect the Controller depending on the output type and any other conditions.) E5CN-[]L Series E5[]K Series Digital Controllers Temperature The temperature output of ES2-THB is the output of a P...
- FAQ01729 for Measuring / Motor Protective Relays |...
- ...he label "L" and the power supply for the sensing line is on the side of the CT with the label "K." Be sure that K and L are connected correctly (see Figure. 2). If the polarity is i...
- faq03139
- ...input terminal polarity. Cable: Terminal: The cable can be inserted in either direction. Either K or L can be connected to the input terminal of the Zero-phase Current Transformer. *Input Ter...
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation