GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
1 CSM_FiberSensor_TG_E_3_1 Sensors Switches Safety...- ...tion output of 200 lx. This is not sufficient to cause malfunction at the operating illuminance limit. Standard sensing object The standard sensing object for both Through-beam Sensors and Re...
https://www.ia.omron.com/data_pdf/guide/499/fibersensor_tg_e_3_1.pdf
- 1 CSM_Temperature_TG_E_6_5 Sensors Switches Safety...
- ...cs of controlled objects is called autotuning. Typical methods are the step response method and limit cycle method. Step Response Method A manipulated variable of 100% is output in steps, the...
https://www.ia.omron.com/data_pdf/guide/53/temperature_tg_e_6_5.pdf
- Sensors Switches Safety Components Relays Control ...
- ... is effective for a smooth start of equipment that is slow in initial heating operation. Output Limit The output range is limited by an upper limit and a lower limit. This f...
https://www.ia.omron.com/data_pdf/guide/54/power_controllers_tg_e_5_2.pdf
- Sensors Switches Safety Components Relays Control ...
- ...compared to the increase in motor line current, the winding temperature exceeds the permissible limit, and the motor will burn up in some cases. Open-phase protection is needed here rather th...
https://www.ia.omron.com/data_pdf/guide/65/epsc_ps_tg_e_2_3_measuring_monitoringry_tg_e_1_2.pdf
- Sensors Switches Safety Components Relays Control ...
- .... For actual performance for short circuit current, refer to the rated breaking capacity (rated limit breaking capacity Icu and rated operating breaking capacity Icu). What is the difference ...
https://www.ia.omron.com/data_pdf/guide/753/lowvoltageswitchinggears_tg_e_2_1.pdf
- Sensors Switches Safety Components Relays Control ...
- ...ts. The motor will not rotate if a load larger than this torque is applied to the motor. Torque Limit A function that limits the output torque of a motor. DC Braking A function that applies a...
https://www.ia.omron.com/data_pdf/guide/9/inverter_tg_e_2_1.pdf
explanation_of_terms.html- ...cs of controlled objects is called autotuning. Typical methods are the step response method and limit cycle method. Step Response Method A manipulated variable of 100% is output in steps, the...
https://www.ia.omron.com/support/guide/53/explanation_of_terms.html
- -1- Guide to the China Compulsory Certification Sy...
- ...n for safety. Examples of CCC Marking for Certified Products The S stands for“safety.” OMRON WL Limit Switch ←Area with mark (enlarged) -4- Application Flowchart to Obtain CCC The following f...
- Sensors Switches Safety Components Relays Control ...
- ... for Cam Positioners Introduction What Is a Cam Positioner? Traditionally, a mechanical cam and limit switch (or a photoelectric sensor or other sensor) were used to detect rotational angles....
https://www.ia.omron.com/data_pdf/guide/12/campositionor_tg_e_2_1.pdf
- Sensors Switches Safety Components Relays Control ...
- ... N·m The force (or torque) that must be applied to the pushbutton to move it from the operating limit position back to the returned position. Total Travel Force (torque) TTF N, N·m The force ...
https://www.ia.omron.com/data_pdf/guide/38/pushbuttonswitch_tg_e_2_1.pdf
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation