GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
FAQ02569 for Servomotors / Servo Drivers | OMRON I...- ...control is possible by installing a DeviceNet Communications Unit (R88A-NCW152-DRT) in an OMNUC W-series Servo Driver. A DeviceNet Communications Unit provides a DeviceNet communications inte...
- FAQ02058 for Solid-state Relays | OMRON Industrial...
- ...turned ON. This is more clearly checked if the dummy load is a lamp with an output of about 100 W. (However, the capacity of the lamp must be within the rated range of the SSR.) MY Best-selli...
- FAQ02152 for Solid-state Relays | OMRON Industrial...
- ...ds can be directly switched without bleeder resistance. Bleeder Resistance 100 VAC 5 to 10 kΩ 3 W 200 VAC 5 to 10 kΩ 15 W Solid-state Relays with DC Output: Leakage current may cause...
- FAQ02155 for Solid-state Relays | OMRON Industrial...
- ...tor must be checked to match the load, but previous experience shows that a resistor of 100 Ω/1 W and a capacitor of 0.1 μF/250 VAC will prevent reset failure. Also, as mentioned above, the l...
- faq02235
- ...heat radiated by Solid-state Relays can be found using the following equation. Heating value P (W) = Output-ON voltage drop (V) x Carry current (A) For example, if a load current of 8 A flows...
- FAQ02237 for Solid-state Relays | OMRON Industrial...
- ...with the power supply to keep the Solid-state Relay ON. Bleeder Resistance 100 VAC 5 to 10 kΩ 3 W 200 VAC 5 to 10 kΩ 15 W MY Best-selling, general-purpose relays that can be selected...
- faq03116
- ...g method Surface mounting 8-pin socket 8-pin socket Flush mounting panel cutout 43.5 x 50.5 mm (W x H) (H3A-Y) 45 x 55 mm (W x H) (H3A + Y92F-40) 45 x 45 mm (W x H) (H3CR-A8...
- faq03132
- ... type Flush mounting: 1 type Mounting method Surface mounting Three M4 screw holes 74 x 102 mm (W x H) Triangle (H2E, -P, 2) 80 x 120 mm (W x H) Triangle (H2E-M, MP) Two M3 screw hol...
- faq03173
- ...Flush mounting) H3AM: 1 type (Flush mounting only) Flush mounting only panel cutout 52 x 66 mm (W x H) (TDS-Y) 53 x 65 mm (W x H) (TDS + Y92F-50) 81 dai. (TDS-LS) 45 x 45 mm (...
- faq01858
- ...'s internal loss becomes heat energy (internal loss = heat produced). Equations: Internal loss (W) = Effective input power - Output power = Output power/Efficiency - Output power Note:Reducin...
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation