GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
faq02235- ...210B Solid-state Relays, the following heating value will be obtained. P = 1.6 V x 8 A = 12.8 W MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- FAQ02237 for Solid-state Relays | OMRON Industrial...
- ...eep the Solid-state Relay ON. Bleeder Resistance 100 VAC 5 to 10 kΩ 3 W 200 VAC 5 to 10 kΩ 15 W MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq02241
- ...he applied voltage may fluctuate within this range. Voltages outside this range cannot be used. MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq03202
- ...the panel or heat sink. However, by using R99-11 Mounting Brackets, the same pitch can be used. MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq03623
- ...ote:Check the manufacturer’s information for how to connect the overvoltage protection element. MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq03628
- ...elays were mounted to the control panel. (Refer to information on mounting Solid-state Relays.) MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq03629
- ...ote:Check the manufacturer's information for how to connect the overvoltage protection element. MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- faq03640
- ...or gang mounting, if the ambient temperature is 50°C, the load current must be kept below 15 A. MY Best-selling, general-purpose relays that can be selected based on operating environment and...
- FAQ00871 for Timers | OMRON Industrial Automation
- ..., the inrush current from the Timer may have damaged the Sensor output. Countermeasure: Use the MY Relay or other relay to turn the Timer power supply ON/OFF. (Make sure that the contact capa...
- faq02579
- ...grammable Controllers Lead Contents FAQ No. FAQ02579 Related Contents Primary Contents Question My 8-second ON-delay timer program that uses a TIM instruction does not run properly. What is t...
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation