GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
3G3MX2-V2 Multi-function Compact Inverter/Specific...- ...nd the wire 4 turns due to the limitation of the wire size, decrease the number to 3, 2, and so on. When the wire can be wound only a single turn, use 4 or more filters side by side, wi...
https://www.ia.omron.com/products/family/3912/specification.html
- R88D-1SN[]-ECT-51 AC Servo System 1S-series with S...
- ...before attempting a megger test (insulation resistance measurement) on a Servo Drive. Not doing so may result in the Servo Drive failure. Do not perform a dielectric strength test on the Serv...
https://www.ia.omron.com/products/family/3923/specification.html
- Further Information of Solid-state Relays | OMRON ...
- ...quick-break fuse in series with the load as an overcurrent protection measure. Design a circuit so that the protection coordination conditions for the quick-break fuse satisfy the relationshi...
https://www.ia.omron.com/support/guide/18/further_information.html
- Further Information of Level Switches | OMRON Indu...
- ... Note: 2.The circuit configuration of the High-sensitivity 61F-[]H Level Controller is designed so that the relay is reset when there is water present between the electrodes. When power suppl...
https://www.ia.omron.com/support/guide/33/further_information.html
Sensors Switches Safety Components Relays Control ...- ... high-frequency switching. Unlimited number of switching operations. Consist of semiconductors, so there is no contact erosion caused by switching. Zero cross function. No operation noise. Et...
https://www.ia.omron.com/data_pdf/guide/18/ssr_tg_e_9_12.pdf
- Sensors Switches Safety Components Relays Control ...
- ...f the time. (2) Terminal Arrangement •Models with a signal start require three external inputs, so they have many terminals. •Models with a power supply start (H3CR-A8) are the H3CR Timers mo...
https://www.ia.omron.com/data_pdf/guide/19/timer_timeswitch_tg_e_7_5.pdf
- Sensors Switches Safety Components Relays Control ...
- ...tput Capacity Output capacity (W) = Output voltage (V)×Load current (I) Select the Power Supply so that the maximum load capacity will be lower than the rated output capacity. Note: The outpu...
https://www.ia.omron.com/data_pdf/guide/22/powersupply_tg_e_8_4.pdf
- Sensors Switches Safety Components Relays Control ...
- ...cation range from standard to high-capacity loads. The fixed rivet contact is usually processed so that it has a groove to eliminate compounds that may be generated as a result of switching. ...
https://www.ia.omron.com/data_pdf/guide/29/microswitch_tg_e_3_4.pdf
- Sensors Switches Safety Components Relays Control ...
- ...-ring or a rubber diaphragm is used for sealing. The rubber seal is not externally exposed, and so resistance is provided against cutting debris from machine tools, but sand and fine shavings...
https://www.ia.omron.com/data_pdf/guide/30/limitswitch_apparatus_tg_e_3_2.pdf
- Sensors Switches Safety Components Relays Control ...
- ...ater; however, at water treatment plants it may refer to water at a stage before it is purified so it has a broader meaning than purified water. Sewage (Sewer) Better described as a wastewate...
https://www.ia.omron.com/data_pdf/guide/33/levelapparatus_tg_e_8_2.pdf
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation