GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
power factor - Glossary index | OMRON Industrial A...- ...Definition The appropriate product category Signal Converters When AC voltage E is applied to a load (e.g., a device), the phase of the AC current I flowing in it generally lags behind or lea...
- open collector - Glossary index | OMRON Industrial...
- ...ion The appropriate product category Temperature Controllers A circuit that is connected to the load through the collector of the transistor, which is extended externally. The appropriate pro...
- leakage current - Glossary index | OMRON Industria...
- ...ategory Solid-state Relays The current that can flow into the output terminals when a specified load voltage is applied to the SSR with the output turned OFF....
- application condition - Glossary index | OMRON Ind...
- ...mechanical conditions under which the customer uses the device, including the current, voltage, load type, operating frequency, and operating speed....
- zero-cross circuit - Glossary index | OMRON Indust...
- ...The appropriate product category Solid-state Relays A circuit that starts operation with the AC load voltage at close to zero-phase....
- zero-cross function - Glossary index | OMRON Indus...
- ...ate product category Solid-state Relays A function that suppresses noise for rapid increases in load current by turning ON the Relay near the zero voltage of the AC load power supply...
- impulse withstand voltage - Glossary index | OMRON...
- ...elay can withstand when the voltage surges momentarily due to lightning, switching an inductive load, etc. The surge waveform, unless otherwise specified, is the standard impulse voltage wave...
- electrical durability - Glossary index | OMRON Ind...
- ...e appropriate product category General Purpose Relays The durability of contacts when the rated load is applied and the contacts are switched at a specified switching frequency. The appropria...
- Further Information of Servomotors / Servo Drivers...
- ...otor Selection Flow Chart Top of page Formulas Formulas for Operating Patterns Inertia Formulas Load Torque Formulas Acceleration/Deceleration Torque Formula Calculation of Maximum Momentary ...
https://www.ia.omron.com/support/guide/14/further_information.html
- explanation_of_terms.html
- ...ecautions for All Proximity Sensors.) Leakage current: A maximum current of 0.8 mA flows to the load current even when the output is OFF. Check that the load will not operate with th...
https://www.ia.omron.com/support/guide/41/explanation_of_terms.html
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation