GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
FAQ02189 for Basic Switches | OMRON Industrial Aut...- ...s Basic model (without seal) --- --- Z, A, D2D, DZ, D2MV, D3C, D2X, D2T, J, D2F, D2MQ, D2MC, X, V, VX, K, SS, D2S, TZ Resists penetration of dirt and dust into the Switch. No protection again...
- FAQ03143 for Basic Switches | OMRON Industrial Aut...
- ...ch WL[]-TH 5 to 120°C Limit Switch VE[]-TH 5 to 100°C Basic Switch TZ -65 to 400°C Basic Switch V[]-T -25 to 150°C Cold-resistant Limit Switches and Basic Switches Switch type Model Cold resi...
- FAQ03331 for Basic Switches | OMRON Industrial Aut...
- ...nted in the desired equipment. You can select from among Z-size General-purpose Basic Switches, V-size Miniature Basic Switches, S-size Subminiature Basic Switches, J-size Ultra Subminiature ...
- FAQ02049 for Limit Switches | OMRON Industrial Aut...
- ...s. Microload Models (Refer to the following information when using the WL01CA2.) Rated voltage (V) Resistive load (A) 125 VAC 0.1 30 VDC It is best to used the WL01CA2 in the range shown in t...
- FAQ00751 for Level Switches | OMRON Industrial Aut...
- ...stance (liquid resistance between E1 and E3) can be calculated with the following equation. R = V⁄I R: Liquid resistance between the electrodes (kΩ) V: Voltmeter's displayed val...
- FAQ00955 for Rotary Encoders | OMRON Industrial Au...
- ...t signal. When using them, pull up to the positive power supply voltage level or pull down to 0 V. The complementary output allows flow-in or flow-out of the output current and thus the risin...
- FAQ01209 for Pressure Sensors | OMRON Industrial A...
- ...the amount of deviation from the rated values for output current (4 mA and 20 mA) or voltage (1 V and 5 V) when zero pressure and the rated pressure are applied at a constant tempera...
- FAQ01447 for Pressure Sensors | OMRON Industrial A...
- ...hysteresis for the E8M-10 Pressure Sensor is ±1% F.S. Converted to voltage, ±1% × 1⁄100 (%) × 4 V (F.S.) = ±0.04 V E2E Standard Sensors for Detecting Ferrous Metals under Standard Co...
- faq02763
- ... capacity for a 200-VAC inductive load. 1.Draw a vertical line where the contact voltage is 200 V (red line). 2.Draw a horizontal line from the point of intersection with the AC inductive loa...
- faq02773
- ...r, but it will still be within 20 ms. 3.Diode characteristics: Reverse breakdown voltage: 1,000 V Forward current: 1 A MY Best-selling, general-purpose relays that can be selected based on op...
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation