GlobalSite Search Results
| Site Search | Product Search | IA Global Search |
previous
faq01132- .... EXCLUSIVE OR Instruction (XORW) Specifications 1.An EXCLUSIVE OR of the corresponding bits in input 1 and input 2 are taken and the results are output to the result word, R. 2.As c...
- faq01468
- ...y Contents Question How do I write a program to delay turning ON a work bit for 1 scan after an input A turns ON and keep the work bit ON for only 1 scan when using a CS/CJ-series Programmabl...
- faq01470
- ...y Contents Question How do I write a program to delay turning ON a work bit for 1 scan after an input A turns ON and keep the work bit ON for only 1 scan? Answer As shown in Figure 1, the p...
- faq01475
- ...o I program ON/OFF delays? Answer Operation Specifications and Data Trace Results CIO 000000: Input A (CIO 0.00) CIO 000200: Output B (CIO 2.00) *Output B (CIO 2.00) turns ON 3.0 s aft...
- faq01477
- ...If the ON and OFF time is 0.5 s or 0.1 s, a Clock Pulse Bit (P_ls and P_0_2s) can be used as an input. The following method can be used to create a flicker program that outputs a pulse-train ...
- faq01479
- ...tion How do I program a one-shot output? Answer In a one-shot program, as long as the trigger input stays ON for longer than a certain time (see note), the output bit will be turned ON for ...
- faq01621
- ...program an ON delay? Answer Operation Specifications and Data Trace Results CIO 000000: Start input bit (CIO 0.00) CIO 000001: Reset input bit (CIO 0.01) W00000: Work bit to store ...
- faq01823
- ...en in Table 1. Instruction Application and characteristics --|↑|-- Can be used only with LD/AND input instructions. DIFU A work bit is required to process the differentiated status. UP A work...
- faq02069
- ...in the ladder program in Figure 1, both BINARY ADD instructions and BCD ADD instructions can be input and displayed in decimal form. The data conversion function of CX-Programmer makes this p...
- faq02260
- ... specifications. *When one of the pushbutton switches from 1 to 32 is pressed, the two words of input data (4-digit BCD data) will be stored in D100 to D131 as shown in the following example....
Top of page
© Copyright OMRON Corporation 2007 -
. All Rights Reserved.
OMRON Corporation